Snap to common angles for measure and cut contours tools

Got a request? Post it here. Please do not post bug reports here.
nabsltd
Posts: 52
Joined: Tue Oct 18, 2016 12:35 am

Snap to common angles for measure and cut contours tools

Postby nabsltd » Tue Apr 25, 2017 3:04 am

It would be nice if we could do something like hold down the "Shift" or "Ctrl" key when we use the measure or cut contours tools to constrain the generated line to common angles (like every 45°).

Bhikkhu Pesala
Top Typographer
Top Typographer
Posts: 6810
Joined: Tue Oct 29, 2002 5:28 am
Location: Seven Kings, London UK
Contact:

Re: Snap to common angles for measure and cut contours tools

Postby Bhikkhu Pesala » Tue Apr 25, 2017 5:00 am

The cut contours tool already does that by holding down Shift. It constrains the cut by increments of 15°

It would be useful to constrain the measure tool to horizontal and vertical at least, but if that's not difficult, then I suppose that 15°increments would be just as easy, and more consistent.
My FontsReviews: MainTypeFont CreatorHelpFC11.0 Pro + MT7.0 @ Win10 1703

nabsltd
Posts: 52
Joined: Tue Oct 18, 2016 12:35 am

Re: Snap to common angles for measure and cut contours tools

Postby nabsltd » Mon May 01, 2017 9:13 pm

Bhikkhu Pesala wrote:The cut contours tool already does that by holding down Shift. It constrains the cut by increments of 15°

I'll have to try again. The last time I did a cut where I specifically wanted it to be at 45°, I couldn't get that to work, so I assumed it wasn't a feature.

Bhikkhu Pesala
Top Typographer
Top Typographer
Posts: 6810
Joined: Tue Oct 29, 2002 5:28 am
Location: Seven Kings, London UK
Contact:

Re: Snap to common angles for measure and cut contours tools

Postby Bhikkhu Pesala » Mon May 01, 2017 9:20 pm

nabsltd wrote:
Bhikkhu Pesala wrote:The cut contours tool already does that by holding down Shift. It constrains the cut by increments of 15°

I'll have to try again. The last time I did a cut where I specifically wanted it to be at 45°, I couldn't get that to work, so I assumed it wasn't a feature.

The feature was new in FontCreator 9.0.

• Knife tool and rotation of contours constrained to increments of 15° by holding the shift key.
My FontsReviews: MainTypeFont CreatorHelpFC11.0 Pro + MT7.0 @ Win10 1703


Return to “FontCreator - Requests and Enhancements”

Who is online

Users browsing this forum: Bhikkhu Pesala and 2 guests