How to display control characters?
Posted: Fri Jun 23, 2023 6:06 am
Hi,
I will like to display the control character font to the screen. This will help to reveal the horizontal tab symbol and carriage return symbol.
Can I assign the value from the range $00 through $1F on the code-point in Glyph Properties panel? Why are Glyphs folder show 32 Unused?
After I press and hold left ALT key and enter 0 through 31 (decimal) in NumPad keys in Microsoft Word, all control characters will be remapped into Unicode value (Greater than 0x2000).
If it is not possible, should I assign zero value to advance width in Glyph Properties panel for each control characters?
Kindly,
Bryan Parkoff
I will like to display the control character font to the screen. This will help to reveal the horizontal tab symbol and carriage return symbol.
Can I assign the value from the range $00 through $1F on the code-point in Glyph Properties panel? Why are Glyphs folder show 32 Unused?
After I press and hold left ALT key and enter 0 through 31 (decimal) in NumPad keys in Microsoft Word, all control characters will be remapped into Unicode value (Greater than 0x2000).
If it is not possible, should I assign zero value to advance width in Glyph Properties panel for each control characters?
Kindly,
Bryan Parkoff