Feature request: Keep the Handle position when removing a point / Joining two points to one
Posted: Tue Jun 14, 2022 8:12 pm
Current behavior:
When removing a point, it also removes the handle positions.
Wanted behavior:
Keep the Handle position when removing a point
OR
Joining two points to one while keeping the handle positions
(Basically the same behavior just in different words)
2 minutes video:
https://www.loom.com/share/93cc4590afe5 ... 54106d3a6a
Important note: This happens when designing in Cubic mode
When removing a point, it also removes the handle positions.
Wanted behavior:
Keep the Handle position when removing a point
OR
Joining two points to one while keeping the handle positions
(Basically the same behavior just in different words)
2 minutes video:
https://www.loom.com/share/93cc4590afe5 ... 54106d3a6a
Important note: This happens when designing in Cubic mode