Template for Fixing Individual Characters

Got a request? Post it here. Please do not post bug reports here.
Post Reply
Erwin Denissen
Moderator
Moderator
Posts: 6644
Joined: Fri Oct 04, 2002 12:41 am
Location: De Bilt, The Netherlands
Contact:

Template for Fixing Individual Characters

Post by Erwin Denissen » Fri Jan 25, 2008 6:36 pm

Beta Tester wrote:One thing I would like to be able to do is print a selective template to fix up individual characters. A couple of mine don't look quite right to me, and I'd like to be able to replace just a few of them. I can never seem to write through the whole alphabet without getting at least a couple of letters printed unsatisfactorily. For example, I did it again, and all of the letters look good and flow well except my lower-case j and n. But if I do a new template, I'll likely make a mistake somewhere else.
Erwin Denissen
High-Logic
Proven Font Technology

Jowaco
Posts: 331
Joined: Tue Oct 15, 2002 11:05 am
Location: York, UK

Post by Jowaco » Fri Jan 25, 2008 7:00 pm

If I were in this position I would save the template to Desktop, open the template in the much undervalued MS Paint and try to repair the erring character drawings. This repaired template could then be saved and, in Scanahand, loaded.

Hope this helps a bit.

Joe.

Bhikkhu Pesala
Top Typographer
Top Typographer
Posts: 6900
Joined: Tue Oct 29, 2002 5:28 am
Location: Seven Kings, London UK
Contact:

Post by Bhikkhu Pesala » Fri Jan 25, 2008 7:00 pm

I think the easiest way to solve this problem is to save the filled in template and edit it in IrfanView or your favourite photo-editor. I find there are a few ink spots that can quickly be cleaned up. Any other method would probably prove to be more time-consuming.

On the Filled Template Dialogue there are buttons for:

1. Copy (copy a scan to the clipboard)
2. Save as (save as a file to disk)
3. Rotate 180° (for those times when you put the template onto the scanner upside down).
My FontsReviews: MainTypeFont CreatorHelpFC11.0 Pro + MT7.0 @ Win10 1703

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest