Eliminating white in intersecting contours or Fill option

Get help with FontCreator here. Please do not post feature requests or bug reports here.
Post Reply
Hugh C. O'Neill
Posts: 14
Joined: Tue Jun 03, 2003 2:42 am
Location: Magnolia, NJ. USA

Eliminating white in intersecting contours or Fill option

Post by Hugh C. O'Neill » Sun Jun 08, 2003 5:06 pm

Hi,
Is there any easy way to fill the white out area that happens when two contours intersect?

Is there an option to prevent this from happening or a feature to easily fill it in?

I noticed that it does not seem to happen when you use contours from the sample toolbar.

Thanks,
Hugh
Learning about fonts has opened a whole new world for me. Fascinating

Joop Jagers
Top Typographer
Top Typographer
Posts: 117
Joined: Sun Jun 08, 2003 9:46 pm

Post by Joop Jagers » Sun Jun 08, 2003 9:50 pm

Change the direction of one of the intersecting contours. Both contours should have the same direction, clockwise or counter clockwise. Please note that intersecting contours are considered bad design.

Post Reply