I have a unicode font with lots of characters. I wish to change the em units from 1000 to 2048. When I try this, the em units change, but the outlines are all reduced. Is there someway to scale all the outlines and bearings at once?
Also, the outlines are all a little small to begin with so something has to change. I can reset the em units to something less than 1000 so that the characters will display and print larger. But I would prefer if possible to stick to the recommended 2048.
Convert from 1000 em units to 2048
-
- Posts: 1
- Joined: Thu Jul 31, 2003 8:24 pm
- Location: Whitehorse, Yukon, Canada
Have you looked at vanisaac's post:
viewtopic.php?p=483&highlight=#483
posted on Wed Apr 02, 2003 7:18 pm?
Is that a possibility?
Joe.
viewtopic.php?p=483&highlight=#483
posted on Wed Apr 02, 2003 7:18 pm?
Is that a possibility?
Joe.