Page 1 of 1
a problem about the Punctuation of cjk
Posted: Mon May 28, 2018 3:10 am
by zoucheng
i have a problem about the Punctuation of cjk....the glyphs is 1000*1000,but we use the punctuation must be 1000*500,the Vertical height must be half....however ,i failed without the vmtx table.....
just like this。。。。what i want is the right one.....
i also try the opentype design
when use the verticalwriting ,the Yadvance will lose 500.。。。
BUT it doensn/t work in photoshop CS6。。。。
Re: a problem about the Punctuation of cjk
Posted: Mon May 28, 2018 7:07 am
by Erwin Denissen
I'm not sure if Adobe Photoshop supports it, so better ask them first.
Re: a problem about the Punctuation of cjk
Posted: Mon May 28, 2018 7:42 am
by zoucheng
Erwin Denissen wrote: ↑Mon May 28, 2018 7:07 am
I'm not sure if Adobe Photoshop supports it, so better ask them first.
thanks for replying。。。。
i have tried ps2017 cc,it doesn't work either....
Re: a problem about the Punctuation of cjk
Posted: Mon May 28, 2018 9:42 am
by Erwin Denissen
So it doesn't support the vert feature, but it does support the vmtx table?
Then do enable Vertical Spacing as explained here:
http://www.high-logic.com/fontcreator/m ... trics.html
- verticalspacing.png (25.08 KiB) Viewed 5278 times
You can then show top and bottom bearings:
http://www.high-logic.com/fontcreator/m ... tions.html
- topbottom.png (11.08 KiB) Viewed 5278 times
This allows you to change them within the glyph edit window.
Re: a problem about the Punctuation of cjk
Posted: Mon May 28, 2018 11:35 am
by Alfred
Shouldn’t the labels for those checkboxes just say ‘Top bearing’ and ‘Bottom bearing’? Since they aren’t on the left or the right, neither of them is really a ‘side’.
Re: a problem about the Punctuation of cjk
Posted: Mon May 28, 2018 3:49 pm
by zoucheng
thx for replying.
sorry,it dosen't work。。。。
in fontlab i can use
Code: Select all
table vmtx{
VertAdvanceY unixxxx 500;
}vmtx;
but fc can't use this code....
Is there a solution instead of this one....
Re: a problem about the Punctuation of cjk
Posted: Mon May 28, 2018 6:07 pm
by Erwin Denissen
Please use the information I provided and let me know your results.