Page 1 of 1

a problem about the Punctuation of cjk

Posted: Mon May 28, 2018 3:10 am
by zoucheng
i have a problem about the Punctuation of cjk....the glyphs is 1000*1000,but we use the punctuation must be 1000*500,the Vertical height must be half....however ,i failed without the vmtx table.....

Image

just like this。。。。what i want is the right one.....

i also try the opentype design
Image
when use the verticalwriting ,the Yadvance will lose 500.。。。
BUT it doensn/t work in photoshop CS6。。。。

Re: a problem about the Punctuation of cjk

Posted: Mon May 28, 2018 7:07 am
by Erwin Denissen
I'm not sure if Adobe Photoshop supports it, so better ask them first.

Re: a problem about the Punctuation of cjk

Posted: Mon May 28, 2018 7:42 am
by zoucheng
Erwin Denissen wrote:
Mon May 28, 2018 7:07 am
I'm not sure if Adobe Photoshop supports it, so better ask them first.
thanks for replying。。。。
i have tried ps2017 cc,it doesn't work either....

Re: a problem about the Punctuation of cjk

Posted: Mon May 28, 2018 9:42 am
by Erwin Denissen
So it doesn't support the vert feature, but it does support the vmtx table?

Then do enable Vertical Spacing as explained here:
http://www.high-logic.com/fontcreator/m ... trics.html
verticalspacing.png
verticalspacing.png (25.08 KiB) Viewed 1323 times
You can then show top and bottom bearings:
http://www.high-logic.com/fontcreator/m ... tions.html
topbottom.png
topbottom.png (11.08 KiB) Viewed 1323 times
This allows you to change them within the glyph edit window.

Re: a problem about the Punctuation of cjk

Posted: Mon May 28, 2018 11:35 am
by Alfred
Erwin Denissen wrote:
Mon May 28, 2018 9:42 am
You can then show top and bottom bearings:
http://www.high-logic.com/fontcreator/m ... tions.html

topbottom.png
Shouldn’t the labels for those checkboxes just say ‘Top bearing’ and ‘Bottom bearing’? Since they aren’t on the left or the right, neither of them is really a ‘side’. ;)

Re: a problem about the Punctuation of cjk

Posted: Mon May 28, 2018 3:49 pm
by zoucheng
Erwin Denissen wrote:
Mon May 28, 2018 9:42 am
So it doesn't support the vert feature, but it does support the vmtx table?

Then do enable Vertical Spacing as explained here:
http://www.high-logic.com/fontcreator/m ... trics.html

verticalspacing.png

You can then show top and bottom bearings:
http://www.high-logic.com/fontcreator/m ... tions.html

topbottom.png

This allows you to change them within the glyph edit window.
thx for replying.
sorry,it dosen't work。。。。
in fontlab i can use

Code: Select all

table vmtx{
 VertAdvanceY unixxxx 500;
}vmtx;
but fc can't use this code....
Is there a solution instead of this one....

Re: a problem about the Punctuation of cjk

Posted: Mon May 28, 2018 6:07 pm
by Erwin Denissen
Please use the information I provided and let me know your results.