Two FC Newbie How-To Questions

D_Spider · Post by **D_Spider** » Tue Jun 21, 2005 10:00 am

In Edit-Contour Mode, is there a way to specify the location of a new point more exactly than by clicking on a point and finding the new point "ahead of" the old one?

And can one set bearings... {edit: I found the answer.}
Thanks for helping!
D_Spider

Bhikkhu Pesala · Post by **Bhikkhu Pesala** » Tue Jun 21, 2005 11:25 am

The precise x,y co-ordinates of the selected point are shown in the status line. Nodes can be nudged by 10 funits using the cursor keys, or by 1 funit by holding down the control key. The Transformation toolbar can also be used to nudge points by a preselected amount, or to a precise x,y position.