Page 1 of 1

Plus sign thingy for knife tool

Posted: Sat Aug 20, 2005 2:49 pm
by RANDY
If one will look at the contour pen tool in FCP,there is a "plus sign thingy"at its tip.It might be helpful to have this same "thingy" added to the knife tool.Sometimes I'll drag guidelines across my letters before I use the Knife tool and try to make a percision cut right on this line.Getting perfect alignment is sometimes difficult.Thanks and have a great day.

Posted: Sat Aug 20, 2005 9:03 pm
by Bhikkhu Pesala
That might help, but also try cutting in points mode. Then the knife will snap to the nodes, making a precise cut easier, that is assuming you want to cut where there are nodes, which is not always the case.

It would help more, I think, if the knife would snap to guidelines.

Re: Plus sign thingy for knife tool

Posted: Fri Jun 24, 2016 4:23 pm
by Bhikkhu Pesala
This feature request has now been implemented in FontCreator 10.
Plus Sign Thingy.png
Plus Sign Thingy.png (483 Bytes) Viewed 942 times