Page 1 of 1
New Glyphs: How Do I set them to specific characters?
Posted: Sun Feb 09, 2020 8:37 pm
by Chatty
Hi.
I created some marks to go over my main letters. How do I set them so that a SPECIFIC KEY types them when installed?
I created them as NEW glyphs.
Re: New Glyphs: How Do I set them to specific characters?
Posted: Sun Feb 09, 2020 9:13 pm
by Bhikkhu Pesala
Keyboard mapping is independent of glyph mapping.
To type accented characters like à you should enable an International keyboard in Windows, then type `followed by the vowel to type àèìòù or ÀÈÌÒÙ.
What accents have you added, and what are their glyph mappings?
Re: New Glyphs: How Do I set them to specific characters?
Posted: Sun Feb 09, 2020 10:09 pm
by Chatty
It is a "ii" glyph, which I represent as a mark beneath the associated consonant glyph. FC12 does not allow me to assign auto-complete code points. I would not know how to assign this mark to a specific key.