i just create this post for everyone for the future who need to fix their problems. this case maybe work for if you have a large of cap-height value and the value near of upem (units per em)
well, the first thing is . i can't find article or post in the forum that help to solve this problem.
if you try to change by this article, https://www.high-logic.com/font-editor/ ... ne-spacing
i think it's not worked anymore, because the problem isn't on there
so, how to solve this?
1. check your upem (units per em) value. by default the value is 2048, i can see it more fonts are set like this value.
2. see, your cap height value size. if you have maybe around 1900-2000 value of cap heigh. you need to change that
or you can find here viewtopic.php?p=48224#p48224But all metrics should be in balance. If the outlines are too small or too large, you should consider increasing or reducing the size of your glyph outlines. We consider outlines too small if the CapHeight is less than ½ upem, and it is too large if is exceeds ¾ upem.
you can adjust that by trying, how that can fit for your fonts,
i did not notice if erwin not tell to see the other fonts value. idk before units per em can change, also it's really hard because there is no auto calculate
i recommended erwin make this article, because mostly i just find article about vertical metric but actually not help until i try to change the upem (units per em)
thanks!