Problem with left bearing at 0 fixed point.
Posted: Thu Jan 25, 2024 1:09 pm
This is a problem if you make a composite glyph.
When sizing using the scale, the left bearing point is fixed at 0,
it will be different from the shape of the glyph I intended. (There was no problem with this because the left bearing was not fixed until Fontcreator version 13.)
Below is an example. I want to use the right corner as a reference point when I use the scale.
Then it should look like a blue letter, but because the left bearing value is fixed, the glyph is automatically resized based on the left.
Then it's not made the way I intended it to be and the 'a' glyph goes out of the 'circle'.
This is a second example.
Increasing the left bearing spacing of the member will distort a composite glyph.
This is also the same problem because the left axis is fixed.
When I work, I have a hard time because of this part
I'm still using version 13.T_T
I hope this part will be updated again like the version 13 or less.
Or is there any way to solve this problem?
When sizing using the scale, the left bearing point is fixed at 0,
it will be different from the shape of the glyph I intended. (There was no problem with this because the left bearing was not fixed until Fontcreator version 13.)
Below is an example. I want to use the right corner as a reference point when I use the scale.
Then it should look like a blue letter, but because the left bearing value is fixed, the glyph is automatically resized based on the left.
Then it's not made the way I intended it to be and the 'a' glyph goes out of the 'circle'.
This is a second example.
Increasing the left bearing spacing of the member will distort a composite glyph.
This is also the same problem because the left axis is fixed.
When I work, I have a hard time because of this part
I'm still using version 13.T_T
I hope this part will be updated again like the version 13 or less.
Or is there any way to solve this problem?