Page 1 of 1
I don't remember the font
Posted: Fri Jun 05, 2015 2:23 pm
by Phosphene
This is quite embarrassing... I made this logo a couple of years ago and I don't remember exactly which it is. I thought it's Brownstone from Sudtipos and the frames are probably done with it but the characters while somewhat similar seem to be with something else. Can anyone help with this? Thanks!
Re: I don't remember the font
Posted: Fri Jun 05, 2015 4:09 pm
by MikeW
I believe it is Monroe. Which I can no longer find available anywhere--it use to be on all the major sites like MyFonts, Fonts.com, etc.
Sent off an email to Studiopos.
Re: I don't remember the font
Posted: Fri Jun 05, 2015 5:15 pm
by Phosphene
You're a life saver! Thanks again!
Re: I don't remember the font
Posted: Fri Jun 05, 2015 6:53 pm
by MikeW
You're welcome.
Mike
Re: I don't remember the font
Posted: Fri Jun 05, 2015 7:49 pm
by Alfred
MikeW wrote:I believe it is Monroe. Which I can no longer find available anywhere--it use to be on all the major sites like MyFonts, Fonts.com, etc.
Sent off an email to Studiopos.
The
Monroe page on the Sudtipos site includes a 'Get font' link to MyFonts.com, but that link invokes a 'Page Not Found' error.
Re: I don't remember the font
Posted: Fri Jun 05, 2015 8:27 pm
by MikeW
Hi Alfred, yes, it's the same story on every site that use to sell it.
I think that font was about the same time frame when Daniel Hernandez went from Studiopos to Latinotype. So there may be an issue there. I have am email off to both foundries.