
just like this。。。。what i want is the right one.....
i also try the opentype design

when use the verticalwriting ,the Yadvance will lose 500.。。。
BUT it doensn/t work in photoshop CS6。。。。
thanks for replying。。。。Erwin Denissen wrote: ↑Mon May 28, 2018 7:07 am I'm not sure if Adobe Photoshop supports it, so better ask them first.
Shouldn’t the labels for those checkboxes just say ‘Top bearing’ and ‘Bottom bearing’? Since they aren’t on the left or the right, neither of them is really a ‘side’.Erwin Denissen wrote: ↑Mon May 28, 2018 9:42 am You can then show top and bottom bearings:
http://www.high-logic.com/fontcreator/m ... tions.html
topbottom.png
thx for replying.Erwin Denissen wrote: ↑Mon May 28, 2018 9:42 am So it doesn't support the vert feature, but it does support the vmtx table?
Then do enable Vertical Spacing as explained here:
http://www.high-logic.com/fontcreator/m ... trics.html
verticalspacing.png
You can then show top and bottom bearings:
http://www.high-logic.com/fontcreator/m ... tions.html
topbottom.png
This allows you to change them within the glyph edit window.
Code: Select all
table vmtx{
VertAdvanceY unixxxx 500;
}vmtx;