Page 1 of 1
[FIXED] Zoom-In Tool often stays on even after Selector tool is clicked
Posted: Wed Aug 10, 2022 7:30 pm
by ChicoThorn
Frequently occurring error: The Zoom-In tool stays active, even after clicking on the Selector tool. Only way to clear it is to: 1) select the Zoom-Out tool, 2) click anywhere in the edit window, 3) click the Reset Zoom to Default tool, 4) and finally click the Selector tool which will now work properly. I'd say this occurs about four to six times or more per hour of editing; frequently enough to be a real nuisance... I've tried to determine if there's a pattern that leads to this error, but so far I've been unable to find any that may be causing it. — This is an error I've experienced for quite some time through many different build versions, although I can't recall how far back it goes.
Re: Zoom-In Tool often stays on even after Selector tool is clicked
Posted: Wed Aug 10, 2022 7:40 pm
by Bhikkhu Pesala
I was unable to reproduce it.
Re: Zoom-In Tool often stays on even after Selector tool is clicked
Posted: Thu Aug 11, 2022 10:37 am
by Erwin Denissen
We do see some anomalies if we zoom in at one glyph panel, then go to another glyph panel and back. We will try to make behaviour more consistent with a next upcoming release.
For now if it happens again, do press the Esc key to revert back to Selection.
Re: [FIXED] Zoom-In Tool often stays on even after Selector tool is clicked
Posted: Tue Aug 23, 2022 9:33 am
by Erwin Denissen
This issue is solved with the update we just released.
Re: [FIXED] Zoom-In Tool often stays on even after Selector tool is clicked
Posted: Wed Aug 24, 2022 1:42 am
by ChicoThorn
Thank you Erwin! That fixed it!
