It is not possible to stick to the auxiliary lines

[shuki]

A problem you previously solved has returned again.
It is not possible to stick to the auxiliary lines

2.gif (11.53 KiB) Viewed 8048 times

[Bhikkhu Pesala]

No such problem here.

Guidelines Option.png (9.65 KiB) Viewed 8046 times

[shuki]

When I try to place the floor of the signal on the baseline, the signal jumps far and precise control is not possible

2.gif (22.34 KiB) Viewed 8044 times

[shuki]

Is there a solution to this?

[Bhikkhu Pesala]

Set a guideline at y = 0 to snap to the baseline.

Horizontal Guide on Baseline.png (7.2 KiB) Viewed 7918 times

Or, show the grid, and snap to the grid.

[Erwin Denissen]

I suspect the contour has been scaled and then it is most likely nodes are no longer positioned at integer values. Go to point mode, select all points (CTRL-A), and then right-click one of the nodes to select "Round XY Coordinates".

[shuki]

Great, is there a way to apply to all characters

[Erwin Denissen]

No, but if more people think this is useful, we might consider adding such feature to the Transform wizard.

[shuki]

This is required in any project with a range of weights.
My working method for creating light weight in font creator software
Occurs when the thin weight is created in the transformation window
Then the shift from the bestline and upper line is created, and in addition the escape
From scratch to go through a project of over 500 characters is a very exhausting job

[Erwin Denissen]

We have added the new transform feature in the upcoming FontCreator 15.

[shuki]

What is the feature called?

[Erwin Denissen]

Round