Page 1 of 1
It is not possible to stick to the auxiliary lines
Posted: Sat Jun 24, 2023 10:16 pm
by shuki
A problem you previously solved has returned again.
It is not possible to stick to the auxiliary lines
- 2.gif (11.53 KiB) Viewed 9922 times
Re: It is not possible to stick to the auxiliary lines
Posted: Sat Jun 24, 2023 10:20 pm
by Bhikkhu Pesala
No such problem here.
- Guidelines Option.png (9.65 KiB) Viewed 9920 times
Re: It is not possible to stick to the auxiliary lines
Posted: Sat Jun 24, 2023 11:45 pm
by shuki
When I try to place the floor of the signal on the baseline, the signal jumps far and precise control is not possible
- 2.gif (22.34 KiB) Viewed 9918 times
Re: It is not possible to stick to the auxiliary lines
Posted: Sun Jul 23, 2023 7:06 pm
by shuki
Is there a solution to this?
Re: It is not possible to stick to the auxiliary lines
Posted: Sun Jul 23, 2023 10:46 pm
by Bhikkhu Pesala
Set a guideline at y = 0 to snap to the baseline.
- Horizontal Guide on Baseline.png (7.2 KiB) Viewed 9792 times
Or, show the grid, and snap to the grid.
Re: It is not possible to stick to the auxiliary lines
Posted: Mon Jul 24, 2023 6:39 am
by Erwin Denissen
I suspect the contour has been scaled and then it is most likely nodes are no longer positioned at integer values. Go to point mode, select all points (CTRL-A), and then right-click one of the nodes to select "Round XY Coordinates".
Re: It is not possible to stick to the auxiliary lines
Posted: Mon Jul 24, 2023 11:27 am
by shuki
Great, is there a way to apply to all characters
Re: It is not possible to stick to the auxiliary lines
Posted: Mon Jul 24, 2023 4:11 pm
by Erwin Denissen
No, but if more people think this is useful, we might consider adding such feature to the Transform wizard.
Re: It is not possible to stick to the auxiliary lines
Posted: Mon Jul 24, 2023 6:27 pm
by shuki
This is required in any project with a range of weights.
My working method for creating light weight in font creator software
Occurs when the thin weight is created in the transformation window
Then the shift from the bestline and upper line is created, and in addition the escape
From scratch to go through a project of over 500 characters is a very exhausting job
Re: It is not possible to stick to the auxiliary lines
Posted: Tue Jul 25, 2023 11:59 am
by Erwin Denissen
We have added the new transform feature in the upcoming FontCreator 15.
Re: It is not possible to stick to the auxiliary lines
Posted: Tue Feb 27, 2024 8:24 pm
by shuki
What is the feature called?
Re: It is not possible to stick to the auxiliary lines
Posted: Tue Feb 27, 2024 9:06 pm
by Erwin Denissen
Round