Okay, found a new bug. Didn’t report it at first, as I thought it was due to the age of my computer, but I just updated to a new system this week and it’s showing the same issue. (I can provide specs for both systems if needed)
Basically, as I’m closing in on the endpoints, the floating point of the cursor goes off the rails. As the cursors didn’t show up in the screen grabs, I circled where they were.
Image 1 shows where it’s aligned with the end point; the red circle matches up nicely.
As I close up, though, the cursor and the point start to deviate. Red shows where it should be, and blue is where it actually is.
Depending on the glyph, it will show up in any number of places, usually within 1 - 5 cursor lengths of where it’s actually supposed to be.
Don’t know if anyone else has reported this but, again, I thought it was initially due to the age of my old system and it turned out that was not the case.